Industries / Heavy Industries

IDX-AMOS FOR HEAVY INDUSTRIES

Built for plants where the equipment is enormous and every stop is expensive.

Connect asset condition, maintenance, energy, safety, and production plans across capital-intensive plants, where every unplanned stop is costly.

Built for plants where the equipment is enormous and every stop is expensive. manufacturing
01 / SOUND FAMILIAR?

If you run a heavy-industry plant,
you have lived these.

One unplanned stop on the main line wipes out the week’s plan.

Energy is one of your largest costs, and nobody can say which shift drove it.

The people who know this equipment best retire in the next few years.

A product takes days to make. A quality problem found at the end loses all of them.

02 / YOUR NUMBERS

What you are measured on,
and what we do about it.

No new dashboards to watch. Each line below is a decision IDX-AMOS helps your team make earlier.

YOU ARE MEASURED ONEquipment availability
WHAT IDX-AMOS DOES ABOUT IT

Degradation patterns seen across sensors, with time to act.

YOU ARE MEASURED ONEnergy per tonne
WHAT IDX-AMOS DOES ABOUT IT

Energy tied to the product, the equipment state, and the shift.

YOU ARE MEASURED ONYield
WHAT IDX-AMOS DOES ABOUT IT

Quality risk flagged during the process, not at the end of it.

YOU ARE MEASURED ONSafety
WHAT IDX-AMOS DOES ABOUT IT

Actions stay inside permits, interlocks, and approvals.

03 / A DAY IN YOUR PLANT

Four moments you will recognize.

Illustrative day

  1. A gearbox on the main drive runs warmer than usual.

    IDX-AMOSRead with vibration and load. Service is planned into the next scheduled stop.

  2. A furnace idles at temperature while waiting for material.

    IDX-AMOSThe loss is seen as it happens, and a holding setting is recommended.

  3. A new operator faces an unfamiliar fault.

    IDX-AMOSGuided through the verified steps an experienced hand would take.

  4. Finished product shows a surface defect at inspection.

    IDX-AMOSTraced to the process stage and when it began. Affected output is identified.

04 / WHERE TO START

Where heavy-industry plants
usually begin.

Start with one workflow. These are the closest fit for the problems above.

START WITH ONE WORKFLOW

Bring one problem from your own plant. We will walk through it with you.